WATER-BASED MOLD RELEASE OIL FOR HOT STEEL FORGING

WATER BASED PROMAX 6000 F is a pale colored solution and is used in HOT STEEL FORGING presses in a much more perfect way instead of Graphite based mold release agents and mold oils. It does not cause odor, smoke and flame, and does not stick. It has absolutely no carcinogenic effect.

FEATURES

The product is easily dissolved in water. First, air is blown into the upper and lower halves of the forging die to remove the remaining scale particles.

After cleaning, when PROMAX 6000 F is sprayed on the inner surfaces of the mold in the usual way, after the evaporation of the water phase it contains,

It forms a thin, solid and white powder-like layer which then disappears completely. This layer is much more than Graphite.

It has superior separating and lubricating properties.

These features ensure that the scale particles remaining in the mold remain separate, allowing the mold to have a long life.

Since it does not contain pigment, the continuity of the product is complete whether diluted or concentrated.

It is used much more effectively wherever graphite oil is used.

BENEFITS OF PROMAX 6000 F IN STEEL FORGING PRESS

• Since it is water based, it does not cause any odor, smoke or flame.

• Before changing the mold, the mold interior can be emptied very easily.

• It has no negative side effects on human health. (It is not carcinogenic!)

• Its use is extremely simple and practical. (It is used by mixing water at a rate of 1 to 9 to 30.)

• Unit cost is cheaper than graphite based oils.

• It eliminates the effects of graphite dust and vapor on sensitive operating systems.

• It has ISO 9002 Certificate.

  APPLICATIONS

  PROMAX 6000 can be used in both automatic and manual spraying systems, with the possibility of adjusting the air/product ratio. 

  During unavoidable stoppages due to product, mold change or other reasons, spraying 

  It is manufactured in a way that prevents the formation of deposits in the hole and the closure of this place. It prevents the formation of deposits in the hole and the closure of this place. 

  small layers can be thinned again using fresh product or plain water. This distinctive feature is hard and easily adhered to the mould parts. 

  It prevents the formation of deposits that cannot be removed. 

PREPARATION PROCEDURE

PROMAX 6000 F is a concentrate (essence) that must be dissolved in water. It is recommended to dilute it as follows before use:

• Place Promax 6000 in a clean container for dilution.

• Add water to the concentrate until it reaches the desired consistency and mix until it is well homogeneous.

  PROMAX 6000 F dissolves easily and only needs a few minutes to do this. MIXING RATIOS

  In Hot Steel Forging Press:

  It can be prepared in a ratio that is selected depending on the physical dimensions and weight of the part to be forged. With automatic or manual spray. 

  It can be sprayed onto the inner surfaces of the mold at a pressure of approximately 4-6 bars and a distance of 20-30 cm. It is graphite based and used for similar purposes. 

  You can safely use Promax 6000 F instead of oils. It is harmless to hands and skin. If it comes into contact with eyes, it is sufficient to wash with water.

  Note: It is recommended to shake the packaging vigorously each time before taking the concentrated product.

  PACKAGING

  220 kg Barrel 34 kg Canister

  The values ​​stated above are obtained with normal production tolerances and therefore do not constitute details.